Clayton WH-105-4, Безопасность, эксплуатация и обслуживание, Страница: 7 / 16

Repair or Warranty Contact Clayton Associates, Inc. • 1650 Oak Street • Lakewood, New Jersey 08701 • P.+1-732-363-2100 F.+1-732-364-6084
WH-4 www.DustlessMadeSimple.com • Sales@JClayton.com
Page 7
If this vacuum is used to collect hazardous material, appropriate personal protective equipment may be required.
The bag filter should be replaced when ¾ full.
1. Safe the vacuum.
• Disconnect the vacuum from power source.
• Remove all hoses from the vacuum.
2. Remove the power head.
• Unlatch the power head from the tank.
•
Lift the power head and the attached HEPA filter off the tank using the top handle.
• Carefully place the power head on the floor – avoid damaging the HEPA filter.
3. Remove the filter bag.
• Grasp the cardboard collar of the bag filter and slide it off the inlet port on the vacuum tank.
• Holding your hand over the opening on the bag, lift the bag out of the tank.
• Dispose of the bag according to company policy.
4. Install a new filter bag.
• Unfold and fluff a new filter bag.
• Push the inlet tube into the hole on the cardboard collar of the filter bag.
• Grasp the sides of the cardboard collar and push it all the way onto the inlet tube.
• Verify the bottom of the collar is past the opening on the underside of the inlet tube.
5. Verify the HEPA filter is seated.
• Holding the power head on its side, examine the HEPA Filter.
•
Verify the white inner ring of the HEPA filter is fully seated against the underside of the power head.
– If it is not, rotate it clockwise until fully seated.
6. Replace the power head.
• Position the power head on the tank.
• Rotate the power head so that the power switch on the Compressed Air Control valve is aligned with the inlet port on the vacuum tank.
• Latch the power head to the tank.
BAG FILTER CHANGE
GL_005
Tank Wall
Tank Wall
Bottom and top of
cardboard bag collar
must be flush to tank
Push cardboard bag
collar past this point
Filter Bag