Clavister SG4500 Series, Руководство по началу работы, Страница: 35 / 87

Running the Wizard Again
Once the wizard has been successfully finished and activated, it cannot be run again. The
exception to this is if the Clavister Security Gateway has its factory defaults restored in which
case the appliance will behave as though it were being started for the first time.
Uploading a License
If the wizard has been run or not, the Web Interface can now be used to upload a valid license to
the Clavister Security Gateway. Without a license, CorePlus will run in
demonstration mode which
means that it will cease to function after two hours of operation (restarting the system will
re-enable CorePlus for another two hours). The steps for license upload are:
• Using a web browser, browse to the License Center section of the Clavister website
https://www.clavister.com and select the option Register New License.
You will require your Clavister Registration Key to register (the key also referred to as the
License Number . For the SG4500 Series, this key can be found written on a label on the
underside or back of the appliance.
• The license center will also require a MAC address to associate with the Clavister license. This
is the hardware Ethernet address associated with one of the Ethernet interfaces on the
appliance. On the SG4500 Series, the MAC address of the default management interface can
also be found written on the label on the underside or back of the hardware.
Alternatively, a MAC address can be read from the output of the ifstat CLI command (this can
be entered via the serial console CLI).
• Now download a valid .lic license file from the license center to the hard disk of the
workstation.
• In the Web Interface menu bar, go to Maintenance > Upgrade and use the Browse button
to select the license file, then upload it. As soon as the license is uploaded, demonstration
mode will end and CorePlus will be restricted only by the limitations of the license.
Chapter 3: CorePlus Configuration
35