If Your Heater Does Not Work
•
Check that power is available to the heater. The
LED light on the SL receiver should be illuminated
•
Check that the fuse in the spur unit has not blown.
This can be done by replacing the fuse with
another suitable fuse.
•
Check if the heater is paired with the SL controller
Should none of the above remedies work, then
telephone the helpline number shown in these
instructions (UK ONLY). Do not attempt to repair the
heater.
Connection to the Main
Supply
Electrical installation should be carried out by a
competent installer, preferably registered with
NICEIC in accordance with the latest edition of the
IEE Wiring Regulations, (BS.7671), and any relevant
Local Authority Bye-Laws. This heater is fitted with a 3-
core mains supply cable and must be permanently
connected to the electricity supply via a double
pole switch having 3mm gap on each pole.
There
are no exceptions
. A switched Fused Connection
unit to BS.1363. Part 4 is a recommended mains
supply connection accessory to ensure compliance
with safety requirements applicable to fixed-wiring
installation.
WARNING:
This appliance must be earthed.
41001555 Iss 02
Overview
Please read this guide carefully and
retain for future use and maintenance.
This appliance has been designed and
manufactured to the highest
international standards. However, care
must be taken for optimal results and
safety. This appliance also meets the
requirements of EU Directive 2004/106/
EC for EMC and 2009/125/EC Directive.
Safety & Care
The appliance is not intended for use
by persons (including children) with
reduced physical, sensory or mental
capabilities or lack of experience and
knowledge unless they have been
given supervision or instruction
concerning use of the appliance by a
person responsible for their safety.
Warning
•
Do NOT site the appliance in a
corner.
•
Do NOT touch the heater when it in
use.
•
Do NOT use the appliance if
damaged.
•
Do NOT leave the appliance
unattended.
•
Do NOT use the heater in hazardous
areas.
•
Do NOT leave the wireless receiver
on top of the heater.
Cleaning
Always isolate the heater from the mains
before cleaning. The heater should not require
any maintenance, but it is strongly advised that
it is kept clean. An occasional wipe over with
a soft cloth is all that should be necessary.
•
Do NOT use metal or furniture polish on any
part of the heater.
•
Do NOT touch the heater with wet hands or
in any way bring water into contact with it.
If the supply cord is damaged, the whole
heater must be.
2
N
E
INDICATOR
LIGHT
L
