3
58000081 Iss 01
1.1 Warnings
All installations must be in accordance
with the regulations in force in the coun-
try of use.
These instructions must be handed to the
user on completion of the installation.
Installers and service engineers must be
able to demonstrate competence and
be suitably qualified in accordance with
the regulations in force in the country of
use.
To ensure continued and safe operation
it is recommended that the appliance is
serviced annually.
The manufacturer offers a maintenance
service. Details are available on request.
The air curtain outlet/inlet grille must not
be obstructed during use.
Any modifications made to the unit not
approved by Consort will void any man-
ufacturers warranty and potentially cre-
ate a hazard.
1.2 Health and Safety
Please read this instructions thoroughly before
installing the appliance. Sole liability rests with the
installer to ensure that all site safety procedures
are adhered to during installation. Sole liability
rests with the installer to ensure that protective
safety wear such as hand, eye, ear and head
protection is used during installation of the prod-
uct. Ensure that all anchoring points are suitable
for the weight of the appliance.
1.3 Electrical Supply
For full electrical loadings, please refer to the
technical data sheets within this manual.
It is recommended that the electrical supply to
the base unit in the air curtain is via an appropri-
ate switched isolator in accordance with the reg-
ulations in force in the country of use and via a
fused isolator having a contact separation of
greater than 3mm in all poles.
BMS control, time switches, room thermostats and
door interlocks can be installed at the discretion
and responsibility of the installer.
All units must be wired in accordance with I.E.E.
regulations for the Electrical Equipment of
Buildings and the installer should ensure that a
suitable isolating switch is connected in the
mains supply.
Electrically heated supply is 415V 3 phase, Neu-
tral and Earth. Max cable inlet size is 4mm² or
6mm² (refer to individual technical specifica-
tion).
Remote unit is wired to the base unit via a
cat5/6 ethernet cable.
1.4 Location
All units should be installed horizontally directly
over the door opening. It is recommended that
the air curtain is installed on the inside of the
building, within the ceiling void or roof space.
Care must be taken to allow complete free air
movement into the inlet grilles of the unit to
ensure correct working operation of the air cur-
tain. The discharge opening should be as close
to the top of the door as possible and cover
the entire door width.
Units can be mounted adjacent to each other
to cover the full door opening across wider en-
trances.
1.5 Clearance Distance
It is recommended that a minimum clearance
of 50mm is allowed around the case sizes de-
tailed below. The clearance allows for cable
entry and prevents combustible surfaces over-
heating.
The minimum mounting height (floor to grille) is
2m. The maximum mounting height is 4m.
1.6 Standards
The heater conforms to the following standards
Electrical Equipment (Safety) Regulations
2016 SI. 2016 1101
Electromagnetic Compatibility Regulations
2016 SI. 2016 No. 1091
Radio Equipment Regulations 2017 SI. 2017
No. 1206
The Ecodesign for Energy Related Products
and Energy Information (Amendment) (EU Exit)
Regulations 2019. SI. 2010 2617
The Restriction of use of Certain Hazardous
Substances. SI. 2012 No. 3032
The Supply of Machinery (Safety) Regulations
2008
(SI 2008/1597)
1. General Information