41001455 Iss 05
4
C
USTOMER
H
ELPLINE
Should you need any advice on the use of your new Consort product please contact our Helpline:
Consort Equipment Products Limited
Thornton Industrial Estate, Milford Haven, Pembrokeshire, SA73 2RT
Tel: 01646 692172 Fax: 01646 695195 Email: [email protected] Web: www.consortepl.com
Operation hours: Mon to Thu 8.30am to 4.30pm | Fri 8.30am to 3.30pm
BS EN ISO 9001 Registered Company No FM12671
Remove the top cover.
Disconnect the internal wiring from the main terminal
block and earth stud.
Release the three fixings which secure the switch bracket
to the right hand of the main case.
Remove the four nuts and washers fixing the fan heater
assembly to the back of the case.
The fan heater assembly can now be eased forward and
removed from the heater case.
Fit replacement fan heater and reassemble in reverse
order.
Noise levels
Sound pressure levels dBA are measured at a 3m distance
with a single air curtain mounted at its maximum mount-
ing height, operating in a room with average acoustic
characteristics as defined in CIBSE Guide B5
(reverberation time 0.7s at 1kHz) and a room size equiva-
lent to 8 air changes per hour (ac/h). The dB meter must
not be in the direct airflow of the heater. Care needs to
be taken when selecting air curtains for an installation as
noise levels can be several dB higher if the mounting
height is reduced, if the room is more ‘live’ (i.e. hard sur-
faces, no furnishings or absorbent materials), if the room is
smaller than 8 ac/h equivalent or a combination of these
factors. Noise levels will also increase if more than one air
curtain is installed at the same doorway (e.g. +3dBA for 2
equal point sources: direct field).
To replace the fan heater assembly
Operation
This heater can only be used in conjunction
with a CRXSL wireless programmable controller
.
Each CRXSL can control any number of heaters
in the same room.
CRXSL
wireless controller
Please refer to the CRXSL installation and control
guide for full operational details.
Wiring diagram
NOTE: The unit MUST be reliably earthed
.
Controls
When the appliance is connected to the
mains supply and the wall socket is switched
‘ON’ the mains neon indicator will light, show-
ing that the power is available to the unit.
