4
ENSURE THE AIR OUTLET OF HE7230SL/RX AND
HE7245SL/RX IS NEAREST TO THE WALL OR
CORNER.
3.1 Mounting
The Claudgen recessed ceiling heaters are de-
signed to fit in place of a standard 600mm ceiling
panel.
IT IS ESSENTIAL THAT THE CEILING FRAME IS ADEQUATE
TO SUPPORT THE WEIGHT OF THE HEATER, OR THAT
THE HEATER IS INDIVIDUALLY SUPPORTED. THERE IS
PROVISION ON THE HEATER FOR CHAIN OR WIRE, SUP-
PORT OR MOUNTING.
The weight of the HE7230SL/RX, HE7245SL/RX is
7kg
The weight of the HE7260SL/RX is 10kg
It is the sole responsibility of the installer to ensure
that the points of attachment to the building are
sound. Care must be taken to allow complete free
air movement into the inlet grilles of the unit to
ensure the correct working operation of the heat-
er. Carefully unpack the unit. The unit is supplied
with a length of self-adhesive foam strip. This can
be cut into lengths and is to be laid on the 4 sides
of the ceiling frame . This will ensure that the unit
assembly is free from vibration. The discharge
grille and diffuser assembly can now be fitted into
the ceiling frame.
4.1 Electrical Connections.
These units are suitable for connection to a
230/240 Volt 50 Hz single phase supply.
The appliance shall be connected to the supply
via an appropriate switched fused double pole
isolator having a contact separation of greater
than 3mm. Test for correct operation and refit the
cover.
3. Installation Details.
Fig.1 Air discharge of HE7230SL/RX and
HE7245SL/RX
Fig.2 Air discharge of HE7260SL/RX
TOP OR SIDE CABLE ENTRY
TERMINAL COVER
For connection to the mains supply it will be
necessary to open the terminal cover at the side/
back of the unit to connect the supply from the
controls prior to refitting the cover. Wire in accord-
ance to the wiring diagrams.
For safety reasons, a sound earth connection
must always be made to the unit before it is put to
use. The unit should be wired in accordance with
IEE Regulations for the Electrical Equipment of
Buildings.
4. Electrical Connections.
41001475 Iss 03
Fig.3 Mounting supports
The wire or chain used to mount the heater can be
attached to 4 of the M6 studs or the 4 x M6
threaded inserts as shown in diagram.
Содержание HE7230SL
Страница 7: ...7...
