58000377 Iss 01
3
Installation
Wall Mounting
Operation
When the appliance is connected to the mains
supply, the LED indicator will light up green, showing
that the power is available to the unit.
When the heat output has been enabled by a
controller, the LED indicator light will turn red.
This heater can only be used when connected to any
SL wireless controller.
Each SL controller can control any number of heaters
providing they are in the RF range.
SLPB
SLTI
SLVT
Please refer to the SL user and operating instructions for
full operational details.
SL wireless controllers
1.
Mark screw fixing positions on the wall in ac-
cordance with dimensions shown on the dia-
gram.
2.
Drill 3 holes for 8mm wall plugs.
3.
Insert plugs in to the holes.
4.
The two end screws can be now screwed in
until the heads are approximately 10mm from
the wall.
5.
Remove the top grille.
6.
Hung the unit on the two end screws.
7.
Secure the unit with the center screws.
8.
Tighten all 3 screws ensuring that the unit is truly
horizontal.
9.
Reattach the top grille.
The heater must be installed in horizontal position.
There must be a minimum clearance of 600mm
above the heater
There must be a minimum clearance of 350mm from
the floor and 200mm from any corner.
SLVTB
