Clatronic WKS 3625, Инструкция по эксплуатации

Страница: 30 / 57

30
Instructions
Preparation
Before using for the irst time, boil fresh water at least three
times in the appliance. Use only water without any additives or
ingredients.
Mains Lead
Completely unwind the length of mains lead that you require
from the bottom section of the base. Please ensure that the
mains lead does not become tangled up.
Electrical connection
Check whether the electrical voltage that you intend to use is
the same as that of the machine. Details are to be found on the
label on the base.
Connected Wattage
The total power consumption of this device can be up to 2200 W.
With this connected load a separate supply line protected by a
16 A household circuit breaker is recommended.
CAUTION: Overload!
• If you use extension leads, these should have a cable
cross-section of at least 1.5 mm².
• Do not use any multiple sockets, as this device is too
powerful.
Use
NOTE:
• Ensure that the ilter is correctly inserted in the spout
opening.
• Always use fresh water.
1. Place the machine on a lat surface.
2. Also hold the kettle by the handle and open the lid.
3. Then ill in the water (max 1.8 Litre). You can read the illing
level on the water level indicator of the kettle.
4. Close the appliance with the lid. It must audibly click into
place.
5. Place the kettle lush on the base.
6. Only connect the machine to a properly installed safety
socket.
7. Switch on the kettle by pressing the switch. The control
lamp will light up.
Pausing / terminating operation
There are two options to interrupt the boiling process or to
terminate it:
• The appliance will shut off automatically after the boiling
process. The indicator lamp will go out.
• Press the switch upwards to interrupt the boiling process,
respectively to terminate it.
WARNING:
Always shut off the appliance before removing it from the
base!
WARNING: Danger of scalding!
• When pouring the water out, keep the lid closed.
• During operation the housing becomes hot. Do not touch
it and allow the device to cool down before storing it
away.
• Hot steam may escape when you open the appliance!
• Disconnect the power cord.
• Emptying the water container.
Mains Cable Take-up Device
The mains cable can be wound up on the base.
CAUTION:
Do not immerse the device into water for cleaning. Please follow the
instructions as stipulated in the chapter “Cleaning”.
Cleaning
WARNING:
• Always turn the device off before cleaning it and remove the mains
plug. Wait until the device has cooled down.
• Never immerse the device or the base in water or other liquids.