Using the Machine
Fine Adjustment of the Voltage (Mains operated Machines)
In case of voltage fluctuations in the mains it may be necessary to adjust the
machine. Switch the machine on. Turn the voltage adjustment screw (6) with a scr-
ewdriver or small coin so that the machine runs as quietly as possible.
Use with the Mains Adapter (Battery Machines)
Connect the machine to the mains adapter. Connect the device to a duly installed
230V/50Hz protective contact socket. The device can now also be used when the
batteries are flat.
Charging the Battery
Before the machine can be used without a cord, the battery must be charged.
Connect the AC adapter to the socket on the device’s suspension eyelet and to a
duly installed 230V/50Hz protective contact socket. The charge control lamp now
illuminates. The first time charging will take approx. 12 hours; for subsequent char-
ging will take´approx. 5 hours. Then disconnect the mains adapter.
Preparing for Cutting
1. Briefly comb the hair.
2. Remove the blade protection.
3. Oil the blades slightly.
4. Place a cutting length guide suitable to the desired cutting length. If you are not
sure of the cutting length, start from 12 mm. Insert the blades in the slot and fit
the attachment on the blade.
5. Insert the plug in a duly installed 230V/50Hz protective contact socket, switch
on the device and run the device with the guide comb upwards and at a con-
stant speed through your hair. The guide is held in a level position.
Cutting without Cutting Length Accessory
This is suitable for trimming the hair. The cutting length can be adjusted continuous-
ly in the range of approximately 0 - 1.2 mm.
For areas which are not accessible to the razor it is possible to use a pair of scissors.
IMPORTANT: Do not use the device for more than 10 minutes. Allow the equipment
to cool down for 10 minutes, before using it again.
Cleaning
• Disconnect the machine from the mains.
• Clean the device after use with a dry cloth. Then wipe off again with a dry cloth.
• The blades and accessories should be cleaned with the brush.
24
GB
4....-05-HSM 2685 22.01.2002 16:09 Uhr Seite 24