Clatronic HL 3763, Инструкция по эксплуатации

Страница: 43 / 74

HL3763_IM_new2 30.07.20
43
Remote Control
NOTE:
The button cell in the battery compartment of the remote
control has been secured with a foil for transport. This
will extend the durability of the battery. Before initial use
please remove this foil so that the remote control is ready
for operation.
The range of the remote control is limited.
When using the remote control, please ensure that there
are no obstacles placed between it and the sensor on the
appliance.
Changing the Battery of the Remote Control
If the range of the remote control is reduced during use,
please proceed as follows:
1. Open the battery compartment on the bottom of the
remote control by holding the lever inwards and pulling
out the battery compartment.
2. Replace the button cell with a battery of the same type
(CR2025). Ensure correct polarity.
3. Then close the battery lid.
Notes for Use
Connected Load
The appliance supports a power input of 2000 W.
CAUTION: Overload
• When using an extension cord, it must have a cable
cross-section of at least 1.5 mm².
• Do not use multi-outlet power strips, since this appli-
ance is too powerful.
• Do not connect any other powerful appliances to the
same electric circuit.
Safety Switch
Your fan heater features a safety switch that disconnects
the power supply in case the appliance falls over. The safety
switch prevents hazards caused by overheating.
CAUTION:
Place the appliance on a smooth, horizontal surface. Avoid
carpets in order to prevent failure of the safety switch.
NOTE:
As soon as the safety switch has been activated, the
appliance must be set and switched on again.
Electric Connection
1. Make sure the voltage of the appliance (see rating label)
matches the mains voltage to be used.
2. Connect the mains plug to a properly installed isolated
ground socket. All indicator lamps light up briefly.
Operating Buttons
The buttons on the appliance are sensor touch buttons. In
order to perform the corresponding function gently touch the
buttons. Whenever a button is pressed, it will be confirmed
by a beep sound.
Control
Panel
Remote
Control
Function
Switching the appliance on / off
Switch display on / off
Time-delayed switch-off:
to hours
Switch oscillation on / off
MODE
Power level selection
( , and )
Increase temperature
Decrease temperature
Operation
NOTE:
• The operation is explained using the buttons on the
appliance.
• The buttons can only be pressed once the appliance
has been switched on by using the button.
Switching the Appliance On / Off
• Press the button to switch on the appliance. The ap-
pliance initiates the fan setting and displays the current
ambient temperature. The indicator lamp lights. To
avoid overheating, the fan is operating continuously.
• Press the button again to switch off the appliance.
NOTE:
A 30 second timer will start in the display. During this
period the fan remains in operation to cool down the
appliance. The indicator lamp lights. When the timer
period has lapsed, the appliance will automatically
switch into standby mode.
CAUTION:
When not using the appliance, disconnect the mains
plug.
Power Level Selection
Press the MODE button repeatedly to choose between the
available power levels.
Fan operation (without heating)
Power level 1 (1300 Watt)
Power level 2 (2000 Watt)
Use the and buttons to select a temperature between
and °C.