CLAS OM 3021, Руководство пользователя, Страница: 4 / 8

OM 3021
JACK STANDS WITH SCREW 20T (x2)
SPECIFICATIONS
SAFETY
USE
MAINTENANCE
Capacity: 20T
Max. height: 600mm
Min. height: 410mm
Base dimensions : 330x330mm
Weight: 26kg
Standards: EK5/AK6 18-03:2018 & AfPS GS 2014:01 PAK
Please read these instructions carefully and retain them for future use.
Failure to heed these warning may result in loss of load, damage to jack stands, and/or jack stand
failure resulting in personal injury or property damage.
WARNING
Do not overload jack stands beyond rated capacity.
Overloading load on center of saddle only. Always use stands in pairs on hard level surface capable
of sustaining the load. Use of stands on other than on hard level surfaces can result in stand
instability and possible loss of load.
1. Refer to your vehicle owner’s manual for proper jacking procedures. Lift only on areas of the
vehicle as specifi ed by vehicle manufacturer.
2. Position stands under vehicle at points specifi ed by vehicle manufacturer as proper load support
points.
3. To adjust stands: Screw low/high stand with controlled pin holes and with turned and oil blocked
sliding part.
4. Carefully lower load onto stands.
Visual inspection shall be made before each use of the stands, checking for cracks, cracked welds
and missing and/or damaged part. Any stand that appears to be damaged in any way shall be
removed from service immediately.
Because of the potential hazards associated with the misuse of equipment of this type, no
modifi cation shall be made to the product.