EQ 3000
AUTOMATIC WHEEL BALANCER 3D WITH LCD SCREEN
The error code can be exited in the following ways:
OPERATOR CONFIRMATION
The machine exits from the error code display when the operator presses any key.
OPERATOR ACTION
The machine exits from the error code display when the operator performs an action linked to said error code (for example, ERR
016 brings the Distance sensor back to the rest position).
ONCE
The machines displays once the error code and its brief description, then it returns to the previous status.
PERMANENT
The machine permanently displays this error code until its turn-off, therefore the error code cannot be exited.
043
The flange for motorbikes was not exactly vertical when
Start was pressed during the MOTO Cal2 and Cal3
calibration phases.
Put the flange for motorbikes exactly vertical (and with the CAL reference on the
upper part) then press [P8] Start.
046
The Diameter sensor is enabled but disconnected.
Press key [P5]: the machine acquisition system is temporarily disabled and operation
can be continued. The disabled status will last until the machine has been turned off.
047
The Width sensor is enabled but disconnected.
Press key [P5]: the machine acquisition system is temporarily disabled and operation
can be continued. The disabled status will last until the machine has been turned off.
051
Hidden Weights program: the selected point is too far from
the external imbalance position.
The point must be included up to 120° from the external imbalance position.
052
Hidden Weights program: the external imbalance position
is not between the selected W1 and W2 points.
Choose W1 and W2 points so that they include the external imbalance position.
055
The static imbalance of the wheel is too low: the Optimiza-
tion program cannot be used.
