CLAS 3701555306544, Руководство пользователя

Страница: 11 / 16

OH 0210
GEARBOX SUPPORT
7 -
Move the rear crosspieces to the centre beam
according to the length of the gearbox. Secure the
front and rear arms against the gearbox.
8 -
Position the two adjusters against the tilting
arms of the front crosspiece and adapt them to
the bell housing. Moving the two supports creates
a stable grip, locking the handwheels with plastic
knob (fi g.7+8).
3
4 5 6
9 -
Now adapt the two tiltable transmission gripping
arms of the rear crosspiece to the transmission
shape and secure them gently using the handwheels
(fi g.9).
10 - Loosen the tilt unit knob under the gear hitch
until the tilt is aligned. This allows the gearbox
attachment to automatically adapt to the inclination
of the gearbox during pumping! (fi g.10)
11 -
Pump the lifting device until the gearbox
attachment makes contact.
Warning: Raise the gearbox as little as
possible!
If necessary, the default settings can now be
corrected again. Now all the handwheels and the
tilt unit fi xing knob can fi nally be tightened.
12 - Remove the gearbox.
The same procedure also applies if a new or
overhauled gearbox must fi rst be removed from the
vehicle and then installed on the vehicle.
Note: even the front bar can be inclined of
5° in both directions, loosen the lower hexagonal
screw on the main bar on the central part. (Fig.11 +
12)
7
8