4
English
Charging the helicopter
The helicopter is charged via the controller.
1. Open the panel on the side of
the controller and withdraw
the charger lead.
2. The on/off switch on the helicopter
should be set to
OFF
.
3. Connect the charger lead to the helicopter.
4. Switch the controller to
ON
.
5. The green charging light on the controller will come on. Charging takes approx. 1 hour.
The helicopter is fully charged when the charging light stops shining.
General flying advice
• Use indoors and not in the vicinity of cooling fans or air conditioning units.
The helicopter can be flown outdoors in good weather.
• Make sure that there is enough free space in the area where you intend to operate
the helicopter.
• Do not fly the helicopter close to fragile objects.
• Both the helicopter and surrounding objects may be damaged if due care is not
exercised during operation.
Operating instructions
1. Switch the helicopter and controller on by setting their on/off switches to
ON
.
2. The helicopter lights will come on and the red ON/OFF light on the controller will
start to flash.
3. Place the helicopter on the ground with the tail nearest you.
4. When the helicopter is synchronised with the controller it will shine red.
Moving up and down
Use the throttle lever to manoeuvre the helicopter up and down. Small, smooth
increments only, are required to make the helicopter fly higher or lower.