7
English
Manual time signal search
A time signal can be searched for manually at any time by holding in the [
▼
WAVE ]
button until the alarm clock emits a short beep. Press [
▼
WAVE ] once again to return
to automatic search mode.
Whilst the search for a radio signal is in progress, non of the buttons on the alarm
clock will work and no signals from the outdoor sensor will be received.
Disabling the time signal reception
The reception of the radio-control time signal can be turned off by pressing and
holding in [
▼
WAVE ] and [
▲
] at the same time for 2 seconds. The time signal can
be enabled again by holding the same two buttons in for 2 seconds again.
Signal strength indicator
Whilst the alarm clock is searching for a radio signal, the strength of the signal can be
checked by pressing [
▼
WAVE ] once.
The strength of the signal is indicated as follows:
•
Display shows
: strong signal.
•
Display shows
or
: weak or no signal.
During reception, the strength of the signal can vary. This is completely normal.
Pressing [
▼
WAVE ] once will return the alarm clock to normal time display mode
and the radio signal icon will appear again.
Manual
time
setting
If the alarm clock cannot receive the time signal automatically, it can be set manually. If
the alarm clock receives a time signal later, the time will then be adjusted automatically.
1. Hold in the [ SET ] button for 2 seconds. The hour digits will flash, press [
▲
] or [
▼
]
to adjust them.
2. Press [ SET ] to confirm and move to the minutes. The minutes digits will flash,
press [
▲
] or [
▼
] to adjust them.
3. Press [ SET ] to confirm. “05” flashes, press [
▲
] or [
▼
] to set the snooze time
(5 to 60 minutes).
4. Press [ SET ] to confirm. “00” flashes, press [
▲
] or [
▼
] to set the time zone
(+1 to -1 hour).
5. Press [ SET ] again to return to normal clock mode. If no button is pressed for
8 seconds, the clock will automatically retun to normal clock mode.
Содержание EN0062-DCF
Страница 2: ...2 ...