Clas Ohlson DJC123-108-UK, Руководство пользователя

Страница: 9 / 12

9
English
Setting the torque
• The power tool has an adjustable clutch to set the required torque with the knob (2).
When correctly set, the power tool stops tightening at the set torque to prevent
the screw being over-tightened.
• The setting depends on the type and size of the screw and the type of material.
Always start with the lowest torque and increase the torque gradually for
the result you want.
Stepless speed control
• Excellent for screwdriving. The more you press the trigger switch (4),
the higher the rotation speed.
• The power tool has an electric brake which operates when you release
the trigger switch, so that the chuck stops quickly.
7. Use
• Choose the accessory you want to use (drill bit, etc), fit it to the chuck and
tighten the chuck.
• To start and stop the power tool, press and release the trigger switch (4).
8. Troubleshooting
Problem Possible cause Action
The motor
does not run. Battery discharged. Check/charge the battery.
Short-circuit. Contact our customer service
department.
Faulty trigger switch.
The motor
runs slowly. Blunt/damaged accessory. Sharpen or replace.
Trigger switch not fully
pressed in.
Press the trigger switch further in.
Motor overheated. Reduce the feed rate.
The power tool
makes an unusual
noise. Mechanical obstruction. Contact our customer service
department.
Winding short-circuited.
Severe vibrations. The accessory is loose
in the chuck. Tighten the chuck, check
the fitting of the accessory.
Sparks inside
the motor. Winding short-circuited. Contact our customer service
department.
Commutator needs
cleaning.