11
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
EMPTYING THE WATER TANK
1. When the FULL indicator
on the control panel illuminates, switch off
the dehumidifier and disconnect it from the mains supply.
2. Carefully remove the water tank
by placing your fingers in the
channel underneath the tank and
pulling it towards you.
• The dehumidifier will beep
several times if it is switched on
and the water tank is removed
or fitted incorrectly.
3. Remove the water tank lid and
discard the water.
4. Replace the lid and refit the water tank.
NOTE:
The unit will not operate unless the water tank is fitted correctly.
CONTINUOUS DRAINING
This function enables continuous dehumidifying without having to empty the
water tank.
1. Remove the knock-out section in
the case, using a small
screwdriver.
2. Attach the drainage hose (not
supplied) to the point shown.
• You may find it easier to
remove the water tank and
work from the inside.
• Make sure that the drain hose
always runs downhill away from
the dehumidifier.
3. Replace the water tank.
• The unit will not operate without the tank in position.
Содержание YDE20
Страница 1: ...OPERATION MAINTENANCE INSTRUCTIONS LS0916 20 LITRE DEHUMIDIFIER MODEL NO YDE20 PART NO 6470682 ...
Страница 2: ...2 Parts Service 020 8988 7400 E mail Parts clarkeinternational com or Service clarkeinternational com ...
Страница 15: ...15 Parts Service 020 8988 7400 E mail Parts clarkeinternational com or Service clarkeinternational com ...
Страница 16: ......