7
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
BEFORE USE
NOTE:
Ensure the compressor is turned off.
1. Remove the plastic blanking plug from the air inlet connection.
2. Pour 2-3 drops of CLARKE airline oil into the inlet port. This should be done
regardless of whether or not a lubricated air supply is to be used.
3. If required, connect an in-line mini oiler to the tool.
• A mini oiler helps to prolong the life of any air tool.
4. Connect a suitable hose as shown
or use the inlet connector supplied
to connect directly to the hose.
5. Connect the other end of the hose
to the compressor.
• PTFE tape may be useful for
sealing threaded connections.
6. Turn on the air supply and check
for air leaks. Rectify any found
before proceeding.
7. If using a mini oiler, place a sheet of paper next the exhaust port and
squeeze the trigger for approximately 30 seconds. The oil volume is
correctly set when a light stain of oil can be seen on the paper. Excessive
oil should be avoided.
Your die grinder is now ready for use.
WARNING: COMPRESSED AIR CAN BE DANGEROUS. ENSURE THAT YOU
ARE FAMILIAR WITH ALL PRECAUTIONS RELATING TO THE USE OF AIR
COMPRESSORS AND COMPRESSED AIR SUPPLY.
Содержание X-Pro CAT206
Страница 16: ......
