Clarke Woodworker CSS400B, Инструкция по эксплуатации и техническому обслуживанию

Страница: 11 / 16

11
TROUBLESHOOTING
MAINTENANCE
A. Apply a thin coat of paste wax on the work table from time to time. This will help the wood
glide across the table more smoothly.
B. The motor is permanently lubricated. Do not try to oil the motor bearings or service any
internal parts of the motor. If the power cable is worn, frayed, cut or damaged, replace it.
Do not try to patch it up with electrical tape as this could lead to more trouble.
Breaking Blades. 1. Incorrect tension. 1. Adjust blade tension.
2. Overworked (worn out) blade. 2. Reduce feed rate or replace
blade.
3. Wrong blade being used. 3. Use narrow blades for thin
wood, wider blades for
thicker wood.
4. Twisting blade in wood. 4. Avoid side pressure on blade.
Motor Will Not Run. 1. Defective cord, plug or outlet. 1. Unplug saw, replace
defective parts.
2. Defective motor. 2. Repairs MUST be made by a
qualified technician. Call
Clarke Service dept. for
advice.
Excessive Vibration 1. Improper mounting of saw. 1. See proper mounting
instructions (p7)
(Some vibration is 2. Unsuitable mounting surface. 2. Replace plywood
inevitable when the workbench surface with solid
saw and motor are lumber surface.
running) 3. Loose table or table rubbing 3. Tighten table adjuster knob.
against motor.
4. Motor mount is loose. 4. Tighten motor mount screws.
Blade Runout 1. Blade holders not aligned. 1. Loosen screws holding
blade holder to rocker arms.
Adjust position of blade
holders.
Retightenholder screws
2. Insufficient Blade tension 2. Increase Blade tension
3. Dull Blade causing excesive 3. Renew Blade and correctly
force to be used at workpiece tension.
PROBLEM PROBABLE CAUSES SUGGESTED REMEDY