Clarke weld MIG 100EN, Инструкция по эксплуатации и обслуживанию

Страница: 15 / 40

15
ASSEMBLY & INSTALLATION
A. LOOSE COMPONENTS
MIG’s, 90EN, 100EN & 105EN
Lay the welder gently on its side and attach the four feet using the screws and flat
washers provided.
MIG 151EN only
Insert the axle through the holes in the rear base of the machine, then attach the
wheels, securing them by pushing the star locking washers provided, on to the axle,
using a piece of tube or an old socket, ensuring the centre tines of the washer face
outwards.
Lay the machine gently on its side and attach the foot to the front base using the
screw and washer provided.
Attach the handle to the top of the machine by slotting it into place and securing with the
screws provided. Slide the handle extension into the handle and secure with the screw
provided.
The gas bottle is secured to the machine using the large worm drive fastening band which
is threaded through the opening provided on the rear panel of the machine.
B. THE WELDING SHIELD
WARNING:
NEVER look at an electric arc without eye protection as this can injure the
eyes permanently. ALWAYS use a protection mask or welding helmet.
1. Push the two halves of the
shield together as shown.
2. Place the handle into
position and secure using
the plastic screw and clip
provided
3. Working from the inside of
the shield, insert the clear
glass panel into the recess
in the shield, followed
by the dark glass panel.
4. Secure the glass panels
with the lens surround and
plastic screws/clips
provided. The clear glass MUST be on the outside of the shield.
5. Finally use the last plastic screw and clip as shown to fix the two halves of the
shield together.