17
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
7. Release the exhaust valve.
8. Turn the self-suction valve to the
on position.
9. Release the trigger lock and pull
the trigger.
10. When the water spray is at high
pressure, close the exhaust valve
and set the suction valve to the
OFF position.
NOTE:
If the water butt runs out of
water, the pressure washer will
need to be primed before use
by repeating steps 4-10.
STORAGE
BEFORE STORING THE PRESSURE WASHER
1. Disconnect the high pressure hose and drain all water from the hose.
2. Coil the hose and store the lance/hose in their respective holders located
on either side of the pressure washer.
STORAGE PROCEDURE
Make sure that the pressure washer has been thoroughly cleaned before
storing it in a clean dry place. See “Maintenance” on page 18.
For long term storage See page 20.
Содержание TIGER 3000A
Страница 28: ......
