Clarke STRONG-ARM CTJ3000G, Инструкция по эксплуатации и техническому обслуживанию

Страница: 4 / 12

4
UNPACKING AND ASSEMBLY
1. Connect the two halves of the
Operating Handle and secure
with a nut and bolt.
2. Remove the packing wedge
shown in fig. 2.
3. Remove the locating screw from
the rear of the handle housing,
shown in Fig 3 and insert the
handle into the housing, ensuring
the square drive on the end of the
handle, engages fully with the
square spigot within the housing.
4. Replace and tighten the locating
screw.
PURGING AIR FROM THE SYSTEM
If air bubbles become trapped inside the hydraulic system during shipping or
transport, the efficiency of the jack will be reduced and the jack will feel
spongy.
1. Turn the control valve counter-clockwise, relieving the pressure inside the
jack.
2. Pump the handle several strokes to purge air from the system.