UNPACKING AND PREPARATION FOR USE
The jack comes fully assembled. It is necessary only to remove the travel plug,
fitted to the Ram, and replace it with the Vent Plug provided. Fig. 1 shows the Vent
Plug fitted at ‘A’.
OPERATION
Ref: Figs. 1 & 2
1.
Move the jack into position beneath the transmission, then turn the Pressure
Valve Knob (B) fully clockwise.
2.
Pump the lever (C) to raise the Table Assembly until it lightly touches the
transmission.
Make all adjustments necessary using the Table Tilt Screw (F), Claws (G), Table
Travel Screw (E), and Angle Brackets (H) , so that the transmission is adequately
and fully supported, and IMPORTANTLY, in the same plane as that when
installed in the vehicle.
Fig. 1
Fig.2
