4
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
SETTING UP
1. Make sure you are loading on a hard, level surface.
2. Turn the engine off, place the vehicle in gear and set the hand brake on.
FITTING THE SECURING STRAP TO THE RAMP
1. Unfold and lay the ramp upside
down.
2. Slide the strap (with a loop) under
one of the cross members and
pass the free end through the
loop as shown.
3. Slide the free end of the strap into
the buckle on the second strap.
• Only pass a few inches through,
so you can tighten this up later.
4. Unfold and place the edge of the
ramp on the bed or tailgate of the
van.
• The tailgate should not be
more than 30" (76 cm) in height
or the ramp will be too steep.
