Clarke SPE1200SS, Инструкция по эксплуатации и обслуживанию

Страница: 7 / 24

7
PREPARATION FOR USE
Because of the variety of possible installations, no plumbing accessories are
supplied with your pump, however accessories designed specifically for this
range of pumps are available from your nearest CLARKE dealer. Contact your
CLARKE dealer for further information, or CLARKE International Sales
Department on 01992 565333.
IMPORTANT: The pump MUST NOT be connected to the mains power supply
until all hose/pipe installation is completed.
POSITIONING THE PUMP
A typical installation of the pump is shown in Fig 1. Connect the suction and
discharge hoses to the pump housing to achieve an air-tight seal. Ensure
there is no damage to the hoses which must be well protected and
supported.
The pump must always be installed
and operated in a horizontal
position i.e. with the outlet port
facing vertically upwards. The
fixing holes in the base should be
used to secure the pump firmly in
its operating position. Always
ensure there is adequate air
circulation around the motor.
Avoid situations where the pump
could become drenched with
water. Neither the motor or
terminal box are designed to be
waterproof.
Position the pump as near to the water source as
possible.
Ensure there is adequate drainage and there is no risk
of damage to property as a result of water being
discharged.
A foot valve/filter should be fitted to the lower end of
the suction hose, as illustrated in Fig 2, in order to retain
water in the suction system and more importantly, to
prevent the possibility of large objects entering the
pump body.
Foot
Valve
Filter
Fig. 2
Fig. 1