4
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
ASSEMBLY AND OPERATION
ASSEMBLY
Your lamp is supplied in three parts;-
• The lamp assembly with arms,
• The G- clamp,
• The holder.
Slide the G-clamp into the slot in the
side of the holder, then slide the lamp
assembly spigot into the holder.
SETTING UP
The G-clamp can be mounted on flat
surfaces and variations in position
can be accommodated by the
angulation of the lamp assembly.
The lamp may be rotated freely in the
holder and the arms set at any angle
by slackening the pinch bolts,
adjusting the angle and re-
tightening.
Do not over tighten the pinch bolts.
When they are correctly tightened, the lamp should be capable of
maintaining stability in any position.
MAINTENANCE
Clean the lens when required with liquid glass cleaner used sparingly and with
a soft dry cloth. Do not allow the fluoresent tube or electrical connections to
get wet.
IMPORTANT: Always switch the lamp
OFF and unplug from the power
supply before cleaning the lens.
The tube will need replacing after
6000 hours of use.
Pull the diffuser to unclip it from the
head. Pull the tube away from its
retaining clips before unplugging the
four-pin connector to release the old
tube. Replace in reverse order.
Содержание SAM100B
Страница 8: ......
