6
Parts & Service: 020 8988 7400/E-mail:[email protected] or [email protected]
HOW TO SELECT TORQUE SETTING
1. With the unit of measurement already chosen, press
the
(
SEt
will
flash briefly
)
and the torque value will be displayed with the first digit
flashing.
•
The value will display for 3 seconds then revert to 0.0, i.e., step 2 must be
commenced within 3 seconds.
•
The value chosen must always be at least 10% of the maximum capability
of the wrench.
2. Press and hold the to zero the display and set another value.
3. Press the
to increase the number until the required value is reached.
4. Press to move to the right and select the next number using the
button.
•
The target torque will display for 3 seconds, then revert to 0.0.
5. Press
to set the value.
OPERATION
1. Connect the bottom (male) square drive of the adaptor, to the socket or
extension bar, perpendicular to the nut/bolt to be tightened.
2. Connect any 1/2” square drive wrench to the top (female) socket of the
adaptor.
3. Smoothly tighten your fastening, applying an even pressure.
•
If in
TRACK
mode, the actual torque applied at any moment will be
displayed. As the target torque setting is approached, the LED will flash
and the alarm will bleep, before a continuous tone and light when the
target torque is reached or exceeded.
•
If in
PEAK
mode, the red LED will light up and the audible warning sound
will be heard when the target torque is reached and the highest
measured reading will be displayed. Press the button to clear this
reading before taking another measurement.
CARE OF THE WRENCH DURING USE
1. Take care not to drop the adaptor on a hard surface and re-set the unit
as described under MAINTENANCE & CALIBRATION, should it be subjected
to sudden shock.
2. Take care not to damage the LCD display.
3. Never apply force with the adaptor when the power is off. Always turn the
unit on before using it.