Clarke Power Wash ELS145, Руководство по эксплуатации и техническому обслуживанию

Страница: 7 / 22

7
OPERATION
Make certain the PUMP ON/OFF switch which is located on the front panel, is set
to the OFF position - marked ‘O’.
ELS145
ELS145R & ELS160R
ALL Models
The low pressure water inlet, shown in Fig. 3, carries a 3/4” BSP thread.
A 3/4” BSP adapter with a 1/2” hose connector is provided, so that a suitable
hose (not supplied), may be attached. You may use a either a worm drive clip
(not supplied), or a snap-on type connector, commonly available from most
hardware or DIY stores, to attach the hose, the other end of which should be
connected to your water supply.
We recommend that you connect to a supply of CLEAN WATER ONLY.
Connect the plug to the mains supply preferably
via a Residual Current Device.
Turn the water tap fully on.
When starting, you should always adopt the
following procedure:
1. In order to ease the starting process, and to
prevent the possibility of blown fuses, pull the
trigger on the lance - it may be necessary to
release the safety latch, please see Fig. 6.
Fig.5
Fig. 6