Clarke Power CI000B, Инструкция по эксплуатации и обслуживанию, Страница: 9 / 16

9
NOTE: The grounding terminal of the AC outlet is connected to the
neutral terminal. This is the same as a standard household power
point where the neutral line is bonded to grounding and there is
normally no voltage between them.
CONNECTING TO POWER SOURCE VIA CIGARETTE LIGHTER PLUG
(CI400B ONLY)
The cigarette lighter plug is suitable for operating the inverter at power
outputs up to 200 Watts. The tip of the plug is positive and the side contact is
negative. Connect the inverter to the power source by inserting the cigarette
lighter plug firmly into the cigarette lighter socket of a vehicle or other DC
power source.
Connect directly to the car battery when operating appliances above 200
Watts.
NOTE: Most vehicle cigarette lighter circuits use fuses rated at 15 to 20
Amps or greater. To operate at full power, either use the battery
clamp cable (supplied) or directly wire to the power source with
suitable wire and fuse (not supplied).
CAUTION: REVERSE POLARITY CONNECTION WILL RESULT IN A BLOWN
FUSE AND MAY CAUSE PERMANENT DAMAGE TO THE INVERTER.
(ALWAYS ENSURE THE LEADS ARE CONNECTED AS BELOW).
CONNECTING TO A POWER SOURCE VIA CABLES
Use the cables provided to connect the inverter directly to the 12 volt power
source using the following guidelines:
1. Check that the inverter power switch is turned OFF and that no flammable
fumes are present.
2. Connect the black cable to the black terminal marked “(-)” on the back
of the inverter. Connect the black battery clip to the negative terminal of
the battery.
3. Connect the red cable to the red terminal marked “(+)”on the back of
the inverter. Connect the red battery clip to the positive terminal of the
battery.
4. Check to ensure that all connections between battery clips and terminals
are clean and secure.
CONNECTING THE LOAD
With the inverter connected to the power source, but switched OFF, ensure
the appliance is also switched off before plugging the cable from the
appliance, into the AC socket on the inverter.
Switch ON the inverter and the green LED will illuminate to indicate that the