-
8
-
Installation
(Figures in brackets refer to Parts list)
IMPORTANT:
Careful consideration is required when choosing the location for the
machine, special attention should be paid to the operation, i.e. the X & Y axis, electric
powerpoint etc, also the workbench where the machine is to be installed should be firm
flat and level. Avoid installing in direct sunshine, damp or very dusty location.
Your new machine is delivered assembled in a wooden case and bolted onto a board
using four bolts. all accessories are packed inside the case in a wooden box.
To remove the machine from the case, it is necessary to dismantle the case first. Once
dismantled ensure all nails etc are removed, safely dispose of the case materials unless
you intend to move the machine at a later date, in that case, store safely away.
Given the machines weight, a suitable hoist etc will be required to lift the machine into
position.
Before lifting, you must ensure that you have given explicit instructions, including who
gives the command to lift etc. Also before lifting, place the machine as near as possible
to the location where the machine is to be sited.
NOTE: when lifting, take care as the machine is top heavy.
1.
Unbolt the machine from the board, and carefully lift into position,
2.
Before drilling the bench, ensure full longitudinal travel is possible, also ensure the
head can be rotated through 360º without fouling etc, anything less could impair
the maximum use of the machine.
3.
Once satisfied, drill four corresponding holes with the ones in the machine base, and
bolt machine securely onto the workbench, using suitable nuts bolts and washers,
(not supplied).
360°
Fig. 1
Head fixing
bolts
Handwheel for
fine feed drilling
Longitudinal feed
hand wheel
Cross Feed Hand Wheel
Longitudinal travel table Locks
Table stops
Handle for rapid
drilling
Head Lock Nuts
Head Handle
Depth stop
-14-
Schematic 230v single phase
Accessories
172
173
178
180
175
176a
176b
176c
108
A wide range of tools and accessories are available from your nearest CLARKE dealer, for
further information, contact your nearest dealer, or telephone CLARKE International Sales
department on 01992 565300.
-
15
-
Содержание Metalworker CMD1225C
Страница 2: ...22 1...
