12
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
REPLACING THE WHEELS
1. Loosen the screws shown and
rotate and remove the wheel
cover.
2. Hold the opposite wheel by hand,
and remove the nut and outer
flange.
NOTE:
The left hand grinding wheel
locking nut has a left handed
thread.
3. Slide off the old wheel and replace with a new one.
• Use only wheels recommended by the manufacturer which have a
marked speed equal to or greater than the speed marked on the
nameplate of the bench grinder.
• The disc should have maximum dimensions of 200 mm diameter, 20
mm thick with a bore size of 15.88 mm.
• Inspect grinding wheel for cracks, chips or any other damage,
damaged abrasive products must be destroyed and discarded.
4. Replace the outer flange.
• Make sure both wheel flanges
are placed with the concave
sides towards the wheel.
5. Replace the nut securely.
• Do not overtighten as this may
damage the grinding wheel.
6. Re-assemble the guards fully prior
to carrying out testing.
• Each time after mounting, the wheel should be test run for a
reasonable time (approximately 1 minute).
CHANGING THE LIGHT BULB
Remove the bulb by twisting it anticlockwise.
Replace with an identical bulb (12V, 10W, ES10 fitting) available from the
Clarke Parts Department.
WARNING: DO NOT USE DAMAGED WHEELS.
WARNING: SWITCH THE GRINDER OFF AND DISCONNECT THE POWER
SUPPLY BEFORE CHANGING THE WHEELS
Содержание Metalworker CBG8370LW
Страница 16: ......
