Clarke METALWORKER CBG6RZ, Инструкция по эксплуатации и техническому обслуживанию

Страница: 5 / 6

1
3
.
USE ONLY APPROVED REPLACEMENT GRINDING WHEELS. Contact your local dealer or Clarke International (081-558 6696) for approved replacement grinding wheels and accessories. The use of inferior accessories may cause risk of injury.
1
4
.
Never use the side of the grinding wheel. Use only the front face.
PRE-ASSEMBLY CHECK
Before assembling your Bench Grinder, please check to ensure that all the parts, shown below, have been included. Note: if any parts are missing or damaged, please contact your local dealer or Clarke International on 081-558 6696 for replacement. 1
.
Main Body (switch and power cable with plug are included).
2
.
Two Eyeshields, each complete with 1 x nut, 1 x bolt, 1 x spring washer and 2 x flat washers (A).
3
.
Two spark arrestor brackets, each complete with 1 x screw, 1 x spring washer and 1 x flat washer (B).
4
.
Two Tool rests, each complete with 2 x screws, 2 x spring washers and 2 x flat washers (C).
4
MAINTENANCE
(A) EYESHIELD and SPARK ARRESTER BRACKET ADJUSTMENT The see-through eye shields allow the user to see the operation clearly and to work precisely. The eye shields can be adjusted up and down to suit operator. The Spark Arrester brackets should be adjusted so that they are as close as possible to the wheel without impairing the wheels rotation. (B) TOOLREST ADJUSTMENT The appropriate adjustment of the Tool Rests provides the operator with a correct working angle and a firm and efficient base for working. Adjustments can be made by loosening the mounting screws and moving the Tool Rest to within 1/16” (1.6mm) from the wheel. Due to the wear on the grinding wheel, it will be necessary to adjust the Tool Rests from time to time. Always re-tighten the mounting screws once adjustment is complete. (C) CHANGING THE GRINDING WHEEL To renew or change the grinding wheels, follow the steps given below. 1
.
Switch off and un-plug from mains power supply. Disassemble outer covers, left or right, by removing the three cover retaining nuts, bolts and washers.
2
.
Slacken the Spark Arrester bracket and Tool Rest mounting screws, and pull the bracket and Tool Rest away from the wheel.
3
.
Hold the grinding wheel firmly and remove the nut and flange from the shaft, noting that the left hand wheel nut has a left hand thread.
4
.
Take off the used wheel and replace with the new one, ensuring: a.
the paper blotters are in place either side of the wheel.
b.
that there is a good balanced rotation of the grinding wheel, and
c
.
you do not overtighten the wheel nut.
5
.
Readjust the Tool Rest and Spark Arrester Brackets as described above.
6
.
Switch
O
N
the machine and allow it to rotate freely for at least one minute.
TECHNICAL DATA
MOTOR
........................................................................
230V ~ 50HZ; 1Ph
SPEED
...........................................................................
2800 RPM
POWER RATING
..........................................................
210Watts
FUSE RATING
...............................................................
5 Amps
WHEEL
SIZE
..................................................................
150 x 20 x12.7 mm
GRINDING WHEELS
.....................................................
1
x Fine; 1 x Coarse
WEIGHT (Packed)
.......................................................
9
KG
DUTY CYCLE
................................................................
5/5
min.
P
A
R
T N
O
.
.....................................................................
6500105
7