12
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
REPLACING THE GRINDING WHEELS
Do not use damaged grinding wheels.
Switch the grinder off and disconnect the power supply.
1. Loosen the screws shown and
rotate and remove the cover.
2. Hold the other wheel by hand, and
remove the nut and outer flange.
3. Slide off the old grinding wheel.
• Use only grinding wheels
recommended by the
manufacturer which have a
marked speed equal to or
greater than the speed marked
on the nameplate of the tool and have maximum dimensions of
150 mm diameter, 20 mm thick with a bore size of 12.7 mm.
• Inspect the wheel for cracks, chips or any other visible damage,
damaged abrasive products must be destroyed and discarded
NOTE:
The left hand grinding wheel locking nut has a left handed thread.
4. Replace the outer flange.
• Make sure both wheel flanges
are placed with the concave
sides towards the wheel.
5. Replace the nut securely.
• Do not overtighten as this may
damage the grinding wheel.
6. Re-assemble the guards fully prior
to carrying out testing.
• Each time after mounting, the wheel should be test run for a
reasonable time (approximately 1 minute).
Содержание Metalworker CBG6250L
Страница 16: ......
