12
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
TROUBLESHOOTING
PROBLEM
CAUSE
REMEDY
Fails to split logs.
Log is improperly positioned.
Refer to “Operating the Log
Buster” on page 10.
Wedge cutting edge is blunt.
Refer to “Sharpening The Wedge”
on page 11.
Oil leaks.
Contact the Clarke service
department.
Unauthorised adjustment was
made to the Maximum
Pressure Limiting Screw.
Contact the Clarke service
department.
The table
moves jerkily.
Excessive air in the hydraulic
system.
Check oil level for possible oil
refilling. Contact the Clarke
service department.
Oil leaks
around cylinder
ram or from
other points.
Air sealed in hydraulic system
while operating.
Loosen Bleed Screw by 3- 4 turns
before operating the log buster.
Bleed Screw is not tightened
before moving the log buster.
Tighten the Bleed Screw before
moving the log buster.
Oil Drain Cap is not tight.
Tighten the Oil Drain Cap.
Hydraulic Control Valve
assembly and / or seal(s) worn.
Contact the Clarke service
department.
Содержание LOGBUSTER 9
Страница 16: ......
