3
Thank you for purchasing this CLARKE, HIPPO JUNIOR Submersible Pump.
This highly efficient pump is designed for
pumping clean water only,
and is ideally
suited for draining ornamental ponds, swimming pools, flooded cellars, etc. It is
not suitable for use as a pond pump. Water temperature must not
exceed 35° C.
DO NOT run this pump continuously - see Duty cycle - Specifications.
The HIPPO JUNIOR incorporates a float switch, which automatically switches the
pump ON when the water reaches approximately 37mm, and OFF when the level
is reduced to approximately 5mm. Levels are adjustable within these limits.
Before attempting to operate your pump, please read this instruction manual
thoroughly and follow all directions carefully, paying particular attention to the
information contained under ‘Electrical Installation’. This is for your own safety
and that of others around you, and to help you achieve long and trouble free
service from your pump.
GUARANTEE
This product is guaranteed against faults in manufacture for 12 months from
purchase date. Keep your receipt as proof of purchase.This guarantee is invalid if
the product has been abused or tampered with in any way, or not used for the
purpose for which it is intended. The reason for return must be clearly stated. This
guarantee does not affect your statutory rights.
Please note that dismantling this pump will invalidate the guarantee
SAFETY PRECAUTIONS
1.
These pumps are designed to pump
CLEAN WATER ONLY.
Never use for pumping
flammable liquids, chemicals, sewage, salt water, oils or corrosive liquids etc.
2.
Never run the pump dry.
3.
An approved Residual Current Device (RCD)
MUST
be used when pumping
from ponds or swimming pools.
4.
Your submersible pump may
ONLY
be used for pumping water from a swimming
pool when there is no person or animal in the pool.
5.
Always disconnect the pump from the electrical supply before placing it into,
or removing it from the water, and before any cleaning or maintenance of
the pump.
6.
Always use the moulded handle with a rope or cord attached when lifting
the pump.
NEVER
lift the pump by the mains cable, or, where fitted, the float
switch cable.
7.
DO NOT
run the pump with the body exposed for longer than 10 minutes.
8.
DO NOT
install the pump on ground which is likely to shift.
9.
Do not use the pump if the water is liable to freeze, as this can damage the
pump. Remove the pump from the water and store it in a frost free location.
