![Clarke GRH35 Скачать руководство пользователя страница 4](http://html1.mh-extra.com/html/clarke/grh35/grh35_operation-and-maintenance-instructions-manual_2614855004.webp)
4
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
GENERAL SAFETY PRECAUTIONS
Read, and make sure you fully understand the following precautions and the
hazards associated with this type of equipment.
1. Check the heater thoroughly for damage. DO NOT operate a damaged
heater.
2. DO NOT modify the heater or operate a heater which has been modified
from its original condition.
3. Use only propane gas.
4. Use only VAPOUR WITHDRAWAL propane supply. If there is any question
about vapour withdrawal, ask your propane dealer.
5. Mount the propane cylinders vertically (shut-off valve up). Secure them
from falling or being knocked over and protect them from damage.
6. Locate propane containers at least 6ft from the heater and do not direct
the exhaust toward containers.
7. IMPORTANT: Use only the hose and regulator assembly provided with the
heater. Inspect the hose assembly before each use of the heater. If there is
excessive abrasion or wear, or hose is cut, replace with the hose assembly
listed on the parts list before using the heater.
8. Not to be used for the heating of habitable areas of domestic premises; for
use in public buildings, refer to national regulations.
9. For indoor use only in well ventilated areas.
10. If at any time gas odor is detected, IMMEDIATELY STOP operation until the
source of gas has been located and corrected.
11. Install the heater such that it is not directly exposed to water spray, rain
and/or dripping water.
12. Maintain minimum clearance from normal combustible material (e.g. like
paper) stated on page 4.
13. Due to the high surface and exhaust temperatures, adults and children
must observe sufficient clearances to avoid burns or clothing ignition.
14. Operate only on a stable, level surface.
15. Do not use with duct work. Do not restrict air inlet or exit.
16. Do not move, handle or service while hot or burning.
17. Use only in accordance with local codes
18. Do not place torsional stress on any hoses.