EN
ENGLISH
Clarke
®
Operator's Manual (EN) - FOCUS C28 and C33
- 15 -
HOW TO OPERATE THE MACHINE
How To Operate the Squeegee
The squeegee wipes the floor while the vacuum motor
removes the dirty solution from the floor. Use your right
hand to lower or raise the squeegee handle. To operate the
squeegee, follow this procedure:
1. To lower the squeegee and start the vac motor move
the squeegee lever to the right and down. See figure
#12.
2. To raise the squeegee, lift the squeegee lever up.
See figure #13.
Note: The center position lets the vac motor continue to
run with the squeegee off the floor to avoid drips.
How to Fill The Solution Tank
CAUTION:
Make sure water or solution
does not enter the opening for
the vacuum motor See figure #14.
The solution tank can be filled in the front or through the
clear drain hose at the rear of the machine. To fill the
solution tank follow this procedure:
1. Remove the solution tank lid. See figure #15.
2. Fill the solution tank with water.
3. Add a cleaning chemical to the water. for the
correct amount, follow the directions shown on the
container.
WARNING:
Water solutions or cleaning materials
used with this type of machine can
leave wet areas on the floor surface.
These areas can cause a dangerous
condition for the operator or other
persons. Always put CAUTION signs
near the area you are cleaning.
WARNING:
Machines can ignite flammable
materials and vapors. Do not use
with or near flammables such as
gasoline, grain dust, solvents, and
thinners. Only use a cleaning concen-
tration recommended by the chemical
manufacturer.
WARNING:
Clarke recommends a maximum
water temperature of 120°F(49°C)
4. Replace the solution tank lid.
5. When filling the machine from the rear, position the
clear drain hose against bracket and insert hose
as shown in figure 16. Solution level can be viewed
from the back of the machine.
Figure #14
Figure #12
Figure #13
Figure #15
Figure #16
