1.
Ensure that the machine is switched off and disconnected from the mains.
2.
First remove the water trough, then remove the two screws securing the
cutting disk cover, beneath the table, and withdraw the cover.
3.
The drive shaft has two flats milled on its end, allowing a spanner (supplied) to
be used to hold the shaft whilst undoing the disk securing nut, again using the
spanner supplied.
Pull off the Disk Flange, followed by the disk.
4.
Take this opportunity to clean the drive-shaft of any foreign matter.
5.
Replace the cutting disk ensuring the direction of rotation is correct. If in
doubt, take note that the shaft rotates in an anticlockwise direction, as you
look directly at it. The disk must be fitted so that the arrow, on the blade,
points in the SAME direction.
6.
Replace the disk flange and screw on the nut, which should then be ‘nipped
up’. DO NOT overtighten.
7.
Replace the disk cover.
CHANGING THE CUTTING DISK
MAINTENANCE
When carrying out servicing or maintenance tasks...ALWAYS disconnect the
machine from the mains supply.
Always rotate the cutting disk by hand before use to check for cracks or distortion.
If any damage is detected, renew the disk.
Check the power cable to ensure it is in perfect condition.
Drain the water tank after use and ensure it is dry before storing.
ALWAYS maintain the machine in top condition. When not in use, keep it covered,
and store in a dry place, not exposed to the elements.
DECLARATION OF CONFORMITY
We declare that this product conforms to the following standards/directives
89/392/CEE, modified by 98/68/CEE (Machinery Directive)
93/68/CEE modified by EN61029-1 (LVD)
98/336/CEE modified by 93/68/CEE (EMC)
5
