14
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
OPERATION
1. Make sure that the tool rest and tailstock are securely locked in position
before starting work.
2. Always rotate the workpiece by hand before turning on the motor and
check it does not strike the tool/tool rest.
3. Always use the lowest speed when starting a new workpiece and roughly
turn the work to a round shape at low speed.
4. Always position the tool-rest just above the centre-line of the workpiece.
5. Avoid turning timber which has splits or substantial knots or voids and take
special care if these are discovered.
6. Take care that the chisels do not bite suddenly into the workpiece.
7. Press the green push-button to start the lathe.
MAINTENANCE
Always inspect before use. Any damage should be repaired and faults
rectified. The lathe requires very little maintenance other than the following
guidelines.
IMPORTANT: Disconnect from mains power before cleaning.
1. Vacuum clean any dust or shavings that accumulate.
2. Check periodically that the power cable is in good condition and not
cracked.
3. Check the tightness of the mounting bolts.
4. Check the drive belt for wear and replace if it is frayed or otherwise
damaged.
5. Very occasionally lubricate the tailstock screw thread and tool-post locking
handles with engine oil such as SAE20 or SAE30 grade if it becomes stiff to
use.
•
The bearings in the headstock and tailstock spindles are greased and
permanently sealed at the factory requiring no further lubrication.
Содержание CWL1000B
Страница 20: ......
