3
Parts & Service: 020 8988 7400/E-mail:[email protected] or [email protected]
GENERAL SAFETY WARNINGS
•
The protective plate in this headshield is breakable and will not protect
against impact hazards.
•
This Headshield is designed for use in arc welding or cutting applications
such as MIG/MAG, TIG, MMA, Plasma Arc, and Carbon Arc.
•
Use this headshield for face and eye protection against harmful rays,
sparks and spatter from welding and cutting.
•
This headshield is not suitable for laser welding, laser cutting or
“overhead” welding applications or for oxy-acetylene.
•
Never place this product on a hot surface.
•
In the event of failure, the headshield remains protected against UV and
IR radiation.
•
Do not make any modifications to this product. Protection can be seriously
impaired if modifications are made.
•
When necessary, use identical replacement parts. This will ensure that the
safety of the product is maintained.
•
Only trained welders should use this product.
•
Do not use without protective plate installed. Do not use if any part of the
headshield is cracked or broken.
•
Do not use this headshield for welding outside the range of DIN 9-13. Harm
to the eyes and impaired eyesight may result.
Please keep these instructions in a safe place for future reference.
PREPARATION & USE
Refer to the part numbers on Page 6.
ASSEMBLY
1. Install headband (8) by removing the thumbscrews (3) individually, and
fasten again after passing each spindle (12) through the holes on the sides
of the hood. Ensure the square lugs of the spacer (15) and back washer
(13) seat in the headshield and the adjustment tab (9) is locked in position.
2. Remove protective film from lens before use.
ADJUST HEADBAND TO FIT
1. The headband (8) should be adjusted both in diameter and height to fit
the wearer’s head. To do this, press the adjustment knob (10) on the back
of the headband and turn the nut either left or right to expand or contract
the headband.
Содержание CWH6
Страница 8: ......
