5
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
2. Use the short beams (C) to
connect the front and rear posts
together.
•
The edge with the wider flange
should be installed uppermost to
support the shelf.
3. Repeat this again to create the
other end assembly, making sure
that the corresponding beams
are at the same height.
4. Join the two end assemblies
together with the long beams (B)
as shown.
5. Connect the support beams (D) to
the long beams (B) by bending the
flexible tabs to 90 degrees and
passing them througthe slots in the
long beams.
•
The tab initially lays flat against the
long beam.
6. Next, bend the tab back through
180 degrees to grip the long
beam.
•
Use a screwdriver or similar tool to
bend the tabs.
7. Finally, bend the tab again
through 90 degrees the opposite
way, to seat tightly against the
support beam.
•
Ensure there is no movement
between the beams.
