4
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
USING THE RAILS
Before using for the first time, perform
a full length cut on a scrap piece of
wood to cut the rubber lip on the rails
flush to the blade.
NOTE:
The saw will cut off a slither of
the rubber leaving a perfect
cut line.
1. Slide the rails up to the cut line.
• The body of the rails should be
placed on the part of the
material you want the keep.
2. Clamp the rails in place using the
supplied clamps as shown.
3. Place the plunge saw onto the
guide rails.
4. Start the saw and push the saw
down until you reach the set
cutting depth.
• Remember to add the
thickness of the rails to your
measured cutting depth.
5. Push the saw forwards to make
the cut.
6. Release the on/off trigger and allow the saw to spring up when the saw
cutting is complete.
