Directions For Use
1.
Ensure floor is firm and reasonably level
before starting, if not, use boards to obtain
it, once satisfied continue as follows.
2.
Seek assistance to lift plasterboard etc into
position.
3.
Set arm/arms to the approximate height
as follows.
a) Lift lever ‘A’ whilst pushing down the top
support plate.
b) Loosen knob ‘B’, withdraw upper support
tube from lower support tube, by holding
lower tube and pulling upper tube upwards, until the desired height is reached, firmly
tighten Knob ‘B’. (hand tight only), With the upper and lower support tubes fully
extended, (see special safety precautions on page 3), more height is required,
continue with C.
c) Lift lever ‘A’ and pull the top support plate upwards, again until required height is
reached, release lever, the support is now ready to use.
4.
Place support arm/arms in a position where they can be easily reached once object
to be supported is in position.
5.
Carefully lift object to be supported into position, place supports underneath and
slowly pump trigger until support is firmly in place.
6.
Check supports are vertical, if not, correct before continuing.
7.
When finished securing plasterboard etc, permanently into position, remove by, either
lifting Lever ‘A’, or loosening Knob ‘B’, and pushing support upwards against ceiling
etc.
Tools and Accessories
A wide range of tools and accessories are available from your nearest CLARKE dealer, for
further information, contact your nearest dealer, or telephone CLARKE International Sales
department on 01992 565300.
-4-
