Clarke CDM65, Инструкция по эксплуатации и обслуживанию

Страница: 4 / 12

4
AC VOLTAGE DETECTION
1. Set the selector switch to the AC WIRE position.
Calibration
2. Hold the unit in the air away from any metal objects,
3. Press and hold the TEST button.
• The unit will beep twice when calibration is complete.
Do not release the TEST button.
Using
4. Keep holding the TEST button and place the unit on the
wall, slowly move the unit sideways across the wall.
• As you approach a live wire, the signal lights will light up
sequentiallly, the buzzer will sound when you reach the
edge of the live wire, when this happens mark the point
by placing a pencil mark in the grove on top of the unit.
5. Carry on moving the unit in the same direction until all
of the signal LEDS go out and then reverse direction.
• Once again, mark the point at which the top LED lights
up and the buzzer sounds by placing a pencil mark in
the grove on top of the unit.
• The centre of the live wire is located mid way between
the two pencil marks.