8
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
OPERATION
VICE OPERATION
1. Turn the handle counterclockwise
to remove clamping pressure.
2. Lift the vice lever up.
3. Pull handle out as far as desired.
• vice may be pushed forward
into the work without turning the
handle.
4. Lower the vice lever then tighten the vice on to the work using the handle.
TRIGGER SWITCH
1. To start the saw, pull the trigger
switch.
2. To turn the saw off, release the
trigger switch.
• Wait a couple of seconds until
the blade reaches full speed.
• Keep hands and materials away
from the wheel until it has come
to a complete stop.
3. To prevent unauthorized use of the
saw, install a padlock (not supplied)
into the padlock hole in the trigger.
TIPS FOR MORE ACCURATE CUTS
• Allow the cutting disc to do the
cutting. Excessive force will cause the cutting disc to glaze reducing
cutting efficiency and/or to deflect causing inaccurate cuts.
• Adjust the fence angle.
• Make sure the workpiece is laying flat across the base.
• Clamp the workpiece securley to avoid movement and vibration.
Содержание CCO14C
Страница 16: ......
