The Motor
Maintenance to the Motor is limited to changing the
carbon brushes.
These will naturally wear with use and require replacing.
They should be checked periodically as follows:
1.
Unscrew and remove the plastic covers on the end
of the motor with a screwdriver
2.
Pull out the brushes complete with springs and
retainers.
3.
Check the brush length, if the ‘wear line’ cannot
be seen (‘A’ fig.8), the pair must be renewed.
4.
Replace the brushes, taking care to ensure that the tabs, on the end of the
spring retainer (‘B’ fig.8), correctly enter the elongated chamber as you push
it in and screw on the cap.
SPECIFICATIONS
Motor Voltage ..................................................... 230V 50Hz 1Phase
Current Rating ..................................................... 10Amps
Power Rating ........................................................ 2,200Watts
Speed ................................................................... 3,750RPM
Disk
Diameter .................................................... 14" (355mm)
Thickness ..................................................... 0.125"
Bore ............................................................. 1"
Weight ........................................................ 18kg
Dimensions (overall) ............................................ 535x310x440mm
For Spare Parts and Service, please contact your nearest dealer,
or CLARKE International, on one of the following numbers.
PARTS & SERVICE TEL: 020 8988 7400
PARTS & SERVICE FAX: 020 8558 3622
or e-mail as follows:
PARTS: [email protected]
SERVICE: [email protected]
PARTS & SERVICE CONTACTS
Fig.8
9
Please note that the details and specifications contained herein, are correct at the time of going to
print. However, CLARKE International reserve the right to change specifications at any time without
prior notice. Always consult the machine’s data plate
Содержание CCO14
Страница 10: ......
