3
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
ASSEMBLY
1. Place the four legs onto the base
plate as shown.
• On one end of the leg there
are 2 holes, this end should go
towards the centre of the base
plate
• On the other end of the leg
make sure that the hole is
pointing towards the floor.
2. Place the lower column onto the
legs and secure using the four
long bolts and spring washers
provided.
3.
4. Slip the tool tray on to the upper
column as shown.
5. Place the spring washer and
washer onto the long bolt.
6. Pass the bolt through one of the
holes in the lower column as
shown.
• The holes provide three
different working heights.
7. Secure using the wing nut.
