4
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
USING THE AXLE STANDS
1. Refer to the vehicle handbook for
the correct jacking procedure and
location of the support points.
2. Fully spread the three legs.
ADJUSTING THE AXLE STANDS
1. Remove the locating pin (if fitted).
2. Raise the upper column to the
required height and fit the locating
pin into the lowest hole visible.
3. Insert the retaining pin into the end
of the locating pin to secure it.
4. Position the axle stand under a
suitable supporting point. See your
vehicle manual for the location.
LOWERING THE VEHICLE
1. Slowly lower the vehicle onto the centre of the saddle.
REMOVING THE AXLE STANDS
1. Raise the vehicle clear of the axle stands and remove the stands. Ensure
that all tools, equipment and personnel are clear before carefully lowering
the vehicle to the ground.
WARNING: BEFORE USE, MAKE SURE THAT THERE IS NO DAMAGE TO ANY
PART OF THE AXLE STAND, IF THERE IS, DO NOT USE.
WARNING: IT MUST BE ENSURED THAT THE VEHICLE/LOAD IS CAREFULLY
LOCATED ONTO THE CENTRE OF THE AXLE STAND SADDLE. FAILURE TO DO
THIS CAN RESULT IN DAMAGE TO THE AXLE STANDS, LOSS OF SUPPORT TO
THE LOAD, SERIOUS PERSONAL INJURY OR LOSS OF LIFE.
WARNING: DO NOT EXCEED THE RATED LOAD OF 2 TONNES (PER PAIR).
WARNING: KEEP HANDS CLEAR WHEN LOADED, DUE TO RISK OF
PINCHING, SHEAR OR CRUSHING HAZARD.
WARNING: DO NOT LOAD THE STANDS OFF CENTRE. FAILURE TO HEED THIS
WARNING MAY CAUSE DAMAGE, INJURY OR LOSS OF LIFE.
Содержание CAX2TFB
Страница 8: ......