8
Parts & Service: 020 8988 7400/E-mail:[email protected] or [email protected]
BEFORE USE
INSTALLING THE DISC
1. To assemble the pad to the tool,
turn the locking nut (A) until the
knurled portion contacts the flat
surface on the output spindle (B).
2. Thread the pad into the spindle
by gripping theorbital hub (C)
with one hand and the pad with
the other.
3. Turn the locking nut until the
spindle turns freely. Do Not
operate the tool with the spindle
in the locked mode as performance would be severly affected and a
hazardous situation could result.
CONNECTING THE AIR SUPPLY
WARNING: COMPRESSED AIR CAN BE DANGEROUS. ENSURE THAT YOU
ARE FAMILIAR WITH ALL PRECAUTIONS RELATING TO THE USE OF
COMPRESSORS AND COMPRESSED AIR SUPPLIES.
Note: Ensure the compressor is turned off.
1. Remove the plastic blanking plug
from the connection port of the
tool as shown.
2. Pour 2-3 drops of CLARKE airline
oil into the air inlet. This should be
done regardless of whether or not
a lubricated air supply is to be
used.
3. Connect a suitable hose to the
tool as shown.
4. Connect the other end of the
hose to the compressor. (A whip hose with a quick fit coupling is available
from your CLARKE dealer).
5. Turn on the air supply and check for air leaks. Rectify any found before
proceding. The tool is now ready for use.
A
B
C
