7
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
BEFORE USE
CONNECTING THE AIR SUPPLY
1. Pour 2-3 drops of CLARKE airline oil into the air inlet. This should be done
regardless of whether or not a lubricated air supply is to be used.
2. Connect a suitable hose to the
tool as shown using the airline
connector supplied with the tool.
3. If required, connect an in-line mini
oiler to the tool.
• A mini oiler helps to prolong the
life of the air tool. Remove the
oil fill screw from the side of the
mini oiler and fill with air-line oil
available from your CLARKE
dealer. Replace the screw before using the tool.
4. If a mini-oiler is not being used, run a few drops of oil through the tool
before use. It can be entered through the air inlet or via the hose at the
nearest connection to the air supply.
5. Connect the other end of the hose to the compressor.
6. Turn on the air supply and check for air leaks. Rectify any found before
proceeding. PTFE tape may be useful for sealing threaded connections.
7. Your air tool is now ready for use.
• You can fit a whip hose with a quick fit coupling if required
(available from your Clarke dealer.)
INSTALLING THE BELT
1. To install or replace sanding belt, slacken the tensioning screw and push
the idler pulley assembly towards the handle against the tension of the
spring, enabling the belt to be removed. Replace the belt and re-
tightening the screw.
WARNING: COMPRESSED AIR CAN BE DANGEROUS. ENSURE THAT YOU
ARE FAMILIAR WITH ALL PRECAUTIONS RELATING TO THE USE OF AIR
COMPRESSORS AND COMPRESSED AIR SUPPLY.
